Dual-Locking, Corrosion-Proof Performance
• Machined to DIN 986, the nut combines an A2/304 stainless-steel body with an internal nylon 6/6 collar and an integral domed metal cap, delivering three independent safeguards against loosening: frictional nylon grip (prevailing torque ≥ 1.8 Nm on M8), thread deformation under clamp load, and impact shielding from the closed cap.
• Austenitic 18-8 stainless provides ≈ 700 MPa tensile strength and resists salt-spray, mild acids, and fertiliser chlorides; the nylon insert remains elastic from −40 °C to +120 °C, preserving torque retention after 1,000 vibration cycles (MIL-STD-1312-7).
• Fully enclosed dome prevents thread damage, electrical arcing, and grime ingress—perfect for outdoor or wash-down assemblies where standard Nylocks leave studs exposed.
Broad, Cross-Industry Compatibility
• Transportation & E-Mobility: Locks battery-pack studs, suspension linkages, and bike stem bolts without thread-locker liquids; stocked by McMaster-Carr, Fastenal, and Würth for aftermarket service kits.
• Food- & Pharma-Grade Machinery: 304 stainless and PA66 nylon comply with FDA CFR 177.1500; used on conveyor guards, bottling lines, and autoclave carts where frequent sanitation is mandatory.
• Renewable Energy & Marine: Secures PV-frame clamps, wind-turbine access ladders, and dock hardware—nylon insert blocks micro-movement that causes galvanic corrosion in coastal climates.
• Consumer Products & Furniture: Provides a child-safe, snag-free finish on playground rigs, fitness equipment, and premium flat-pack furniture; compatible with IKEA-type M6/M8 studs.
快速、 方便操作的处理
• Standard hex drive works with any open-end or socket wrench; the nylon collar allows “start-by-hand” threading yet delivers prevailing torque throughout the service life—no need for secondary lock washers.
• Low round-dome profile (≈ 30 % shorter than DIN 1587 acorn nuts) means fewer turns to full seating, reducing assembly time by up to 25 %.
• Offered in loose bulk, resealable poly-packs, and tape-&-reel formats supporting both manual workcells and automated pick-and-place feeders.
优质品质与合规保障
• Every lot is 100 % vision-inspected for nylon-insert depth, cap concentricity ≤ 0.03 mm TIR, and burr height < 0.05 mm; SPC reports available for ISO 9001, IATF 16949, or PPAP Level 3 submissions.
• Passivated per ASTM A967, optionally electropolished or powder-coated in RAL/Pantone colours for brand coding without compromising thread fit.
• Supplied with RoHS 3, REACH, and DFARS material certificates plus QR-coded traceability back to melt lot—meeting audit requirements across aerospace MRO, medical-device fabrication, and semiconductor tooling.
