Stainless Steel Hex Washer Head Self Drilling Screw-Self Tapping Sheet Metal Screw

description

1. Performance & Material Properties
   • AISI 410 Stainless Steel Construction: Martensitic stainless steel offers a balanced combination of strength (tensile ≈600 MPa) and hardness (≈30–36 HRC) while retaining good corrosion resistance in mild to moderate environments.
   • Self-Drilling “TEK” Tip: Hardened to RC 45–50, the precision ground point drills through 0.5–1.2 mm light-gauge steel and aluminum without a pilot hole, enabling fast penetration and clean chip evacuation.
   • Integrated Hex Washer Head: 6 mm (¼″) hex washer head provides a broad bearing surface for even load distribution, resists cam-out at torques up to 12 Nm, and minimizes surface indentation on soft substrates.
   • Optional EPDM Sealing Washer: A bonded elastomer washer delivers IP65-grade sealing against water and dust ingress, preventing leaks in exterior cladding, roofing, and HVAC assemblies.
2. Detailed Application Range
   • Sheet-Metal Fabrication: Fastening HVAC ductwork, electrical enclosures, metal roofing & siding panels, and architectural trim.
   • Structural Framing & Drywall Tracks: Assembling light-gauge steel studs and track systems in commercial and residential construction.
   • Automotive & Transportation: Securing brackets, cable trays, and interior panels where corrosion resistance and vibration resistance are required.
   • Equipment & Appliance Manufacturing: Mounting control panels, metal housings, and equipment guards in environments subject to occasional wash-down or condensation.
3. Effortless Installation & Operation
   • One-Step Fastening: Self-drilling tip eliminates the need for a separate drilling operation, reducing cycle time by up to 50% compared to conventional screws.
   • High-Torque Compatibility: Standard 6 mm hex head fits common ¼″ nut drivers and hex-bit sockets, enabling rapid, slip-free drive with electric or pneumatic tools.
   • Controlled Depth & Clean Finish: Washer head seats flush to slightly proud for consistent clamp load; built-in stop shoulder prevents over-driving and material distortion.
   • Quick Rework & Adjustment: Screws can be backed out and reinserted cleanly without damaging the drilled hole, facilitating on-site modifications.
4. Superior Quality & Long-Term Reliability
   • ISO 9001-Certified Production: Manufactured to ANSI B18.6.2 / ISO 14583 dimensional tolerances (±0.1 mm on diameter, ±0.2 mm on length), ensuring interchangeability across suppliers.
   • Corrosion & Sealing Tested: Passivated finish and EPDM washer assemblies endure ≥240 h salt-spray per ASTM B117 without pitting, guaranteeing reliable performance in exposed installations.
   • Full Traceability & Compliance: Lot-by-lot material certification from melt to finished part; RoHS- and REACH-compliant, free of restricted substances and magnetic anomalies.
   • Consistent Drive Performance: Each batch undergoes drive-torque and head-pull-off testing to validate slip-resistance and load capacity, delivering dependable fastening in high-vibration environments.